Licensed, Bonded & Insured in Washington info@firstchoiceroofservice.com Toll-free 1-800-766-3927

Roof Repair · September 10, 2026 · 5 min read

Chimney Leaks: Why the Flashing Fails and What a Real Fix Looks Like

Chimney and flashing detail on a composition roof

Short answer: chimney leaks are flashing failures. The metal system that seals the roof-chimney junction eventually corrodes or pulls loose — and because generations of quick fixes reach for caulk instead of metal, many older Puget Sound chimneys are wearing a crust of failed sealant over failed flashing. The durable repair rebuilds the metal.

Why this junction fails first

A chimney punches through the roof plane and stands independent of it — the house settles, framing expands, masonry doesn't move in sync. Meanwhile the roof sheds its water around the obstruction, concentrating flow exactly where the joint is. It's the hardest-working seal on the roof, engineered as a two-part system so each layer can move slightly without breaking the other: step flashing woven shingle-by-shingle up the sides, and counter flashing set into the mortar joints above, lapping down over the steps.

How it actually fails

  • Corrosion — decades of Puget Sound moisture eventually win against the metal, especially older galvanized steel.
  • Mortar joint separation — counter flashing pulls free as mortar ages, leaving a gap that faces the sky.
  • The caulk archaeology — each prior owner's tube of sealant, stacked in layers, each one a temporary patch that made the junction harder to repair properly. We see it weekly on older Seattle homes.
  • Missing cricket — wide chimneys need a small diverter roof on their uphill side; without one, water and debris pond against the back face.

The real repair

Rebuild, don't recoat: new step flashing woven into the courses, new counter flashing ground into the mortar joints and sealed, a cricket where dimensions call for one. Done properly, the junction outlasts the shingles around it — which is also why chimney flashing should be automatically renewed during any roof replacement on an older home. It's a standard part of our repair work across Seattle and the Eastside.

Stains on the ceiling near your chimney? Get it diagnosed free, with photos: (425) 270-1525.

Frequently Asked Questions

Why do chimneys leak where they meet the roof?

The roof-chimney junction joins two structures that move independently, sheds concentrated water, and relies on a two-part metal flashing system to stay sealed. When that flashing corrodes, separates from mortar joints, or was 'repaired' with caulk over the years, water enters — typically showing up as stains on the ceiling near the chimney.

Is caulking a chimney leak a real repair?

No — it's a postponement. Sealant over failed flashing buys months while water finds the next gap, and layers of old caulk actually complicate the eventual proper repair. Real repair means rebuilding the step and counter flashing, with the counter flashing let into the masonry joints.

What does proper chimney flashing involve?

Two interlocking layers: step flashing woven into the shingle courses along the chimney sides, and counter flashing embedded into the mortar joints and lapped over the steps. Add a cricket (a small diverter roof) behind wide chimneys. Done correctly it outlasts the roof around it.

Do older Seattle-area homes have worse chimney problems?

Generally yes — original masonry chimneys have often outlived two or three roofs, and each reroof either renewed the flashing properly or worked around it. Craftsman and mid-century homes across Seattle and the Eastside are where we most often find flashing that's decades past its service life.